Chipkit UNO and 4067 LED output example

In this example we will connect a 4067 to our Chipkit UNO, at the expense of 5 I/O lines you can get 16 outputs (or inputs)

The HEF4067B is a 16-channel analog multiplexer/demultiplexer with four address inputs (A0 to A3), an active LOW enable input (E), sixteen independent inputs/outputs (Y0 to Y15) and a common input/output (Z). The device contains sixteen bidirectional analog switches, each with one side connected to an independent input/output (Y0 to Y15) and the other side connected to the common input/output (Z). With E LOW, one of the sixteen switches is selected (low-impedance ON-state) by A0 to A3. All unselected switches are in the high-impedance OFF-state. With E HIGH all switches are in the high-impedance OFF-state, independent of A0 to A3. The analog inputs/outputs (Y0 to Y15 and Z) can swing between VDD as a positive limit and VSS as a negative limit. VDD to VSS may not exceed 15 V.

Here is the pinout of the 4067

4067 pinout

You can see depending on the state of pins S0 – S3 determines the output channel pin that is used. So if S0 to S3 are 0 then Channel 0 which is Pin 9 is selected

4067 truthtable

 

Schematic

Here is a schematic, in this example we only connected 8 sets of LEDs and resistors but its easy to add another 8 from X8 to X15

Chipkit and 4067

Code

The code example only uses 8 LEDs

If you want to use more than 8 change the for loop – chipkitPin < 7

for (int chipkitPin = 2; chipkitPin < 7; chipkitPin++)


[codesyntax lang=”cpp”]

const int channel[] = {2, 3, 4, 5};

//the output pin - mux input
const int outputPin = 6;

void setup() 
{
 // set up all pins as output:
 for (int chipkitPin = 2; chipkitPin < 7; chipkitPin++) 
 {
 pinMode(chipkitPin, OUTPUT);
 }
}

void loop() 
{
 //iterate through the first 8 channels of the multiplexer (change to 16 if you 
 //have 16 LEDs or outputs connected)
 for (int muxChannel = 0; muxChannel < 8; muxChannel++) 
 {
 //set the channel pins based on the channel you want
 //LED on - high - 100 milliseconds delay
 muxWrite(muxChannel);
 digitalWrite(outputPin,HIGH);
 delay(100);
 }
}

void muxWrite(int whichChannel) 
{
 for (int inputPin = 0; inputPin < 4; inputPin++) 
 {
 int pinState = bitRead(whichChannel, inputPin);
 // turn the pin on or off:
 digitalWrite(channel[inputPin],pinState);
 }
}

[/codesyntax]

Related posts

DsPIC30F4011 Development Board OLED example

DsPIC30F4011 Development Board push button example

DsPIC30F4011 Development Board flashing LED example

This website uses cookies to improve your experience. We'll assume you're ok with this, but you can opt-out if you wish. Read More